Rules of Origin for steel l sections (angles), hot-rolled, height under 80 mm — Dubai (UAE) to India
HS 72162100 · ANGLES · Rules of Origin & preferential rate
Data last updated: · MFN duty & IGST verified against ICEGATE (Indian Customs EDI). Rules of Origin per CEPA Annex 3B. Verify your exact HS line before filing.
- CEPA eligible
- Yes
- Value addition (RVC)
- 40%
- Tariff-classification change
- CTSH Annex 3B rule set at chapter level — it covers the whole chapter, not this code alone
- MFN → CEPA basic duty
- 15% → 0%
Rule of Origin (CEPA Annex 3B, primary source): CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).
Qualifying under the Rules of Origin
To claim the CEPA preference on steel l sections (angles), hot-rolled, height under 80 mm (HS 72162100), the goods must qualify as UAE-originating. The Product-Specific Rule (Annex 3B) is "CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required)": the goods must undergo a change of tariff sub-heading (CTSH) AND add at least 40% regional value content — both conditions, not either/or. Read that rule for what it is: Annex 3B supplies it at chapter level as the residual rule, applying to the chapter apart from the lines given their own, so it governs hundreds of eight-digit codes rather than this one. It is the correct rule to apply, and it is also the place to check for a more specific carve-out before committing to a claim. Steel angle is among the most widely used structural products in Indian construction and fabrication, from towers to shelving to general engineering. CEPA removes the full basic duty. The 40% value-content rule depends on melt-and-roll origin, which the mill test certificate records directly. The section trade is heavily exposed to trade-remedy measures that operate independently of CEPA and can exceed the basic duty they sit on top of, so screening the specific section and source is not optional. The Steel Quality Control Orders add a third check: BIS certification of the producing mill is required, and an uncertified mill's consignment is refused clearance whatever its origin. All three questions resolve to the same fact. Because angle is a commodity bought largely on price, the duty differential frequently decides the order — but only if the origin claim survives audit. A valid Certificate of Origin filed through the eCoO 2.0 system must accompany the shipment; without it, customs charges the 15% MFN rate instead of the preference.
Check your own figures in the Rules of Origin (RVC) qualifier. Qualifying is only half of it — the preference is claimed with a Certificate of Origin, issued in the UAE before shipment or retrospectively within 12 months.
Frequently asked questions
- Does steel l sections (angles), hot-rolled, height under 80 mm qualify for India–UAE CEPA?
- Yes, if it meets the Annex 3B Product-Specific Rule "CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).": it must BOTH change tariff classification (CTSH) AND add at least 40% regional value content — both conditions are required, not either/or.
- What is the Rule of Origin for steel l sections (angles), hot-rolled, height under 80 mm?
- Per CEPA Annex 3B: CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).. RVC% = [(FOB − value of non-originating materials) / FOB] × 100 (FOB basis).
- What proof is needed at import?
- A preferential Certificate of Origin filed through eCoO 2.0, presented at customs before clearance. Without it, the 15% MFN duty applies.